Reassembly
1.
Wrap tape around the driveshaft
spline(TJ) to prevent damage to the boots.
2.
Apply grease to the joint boot
on the side of the wheel and install the boot.
...
Installation
1.
Apply a light coat of engine
oil to the oil cooler packing surface (A), and then install the oil cooler
with fix bolt (B).
Tightening torque:44.1
~ 53.9 N.m (4.5 ~ ...
Additional Programming for Rolling Code Devices
For any rolling-code-equipped device; follow the steps below after completing
the "Programming" section. A second person may make the following steps easier.
1. Locate the "learn&quo ...