Inspection
Power Seat Motor1. | Disconnect the connectors for
each motor. A : Front height motor B : Slide motorC : Rear height motor D : Recline motorE : Lumber support motor
|
2. | With the battery connected directly to the motor terminals, check if the motors run smoothly. |
3. | Reverse the connections and check that the motor rotates in reverse. |
4. | If there is an abnormality, replace
the motors.
|
1. | Disconnect the limit switch and operate the limit switch. |
2. | Check for continuity between the terminals. |
3. | Make sure that the seat operation is normal in the reverse after the maximum operation. |
4. | If there is an abnormality, replace
the limit switch.
|
Inspection
1.
Check the engine oil quality.
Check the oil deterioration, entry of water, discoloring of thinning. If
the quality is visibly poor, replace the oil.
2.
Check t ...
Water pump. Components and Components Location
Components
1. Water pump pulley
2. Water pump sub assembly
3. Water pump gasket
4. Water pump cover
5. Water pump cover gasket
6. O-ring
7. Water inle ...
Push-starting
Your manual transaxle-equipped vehicle
should not be push-started because it
might damage the emission control system.
Vehicles equipped with automatic
transaxle cannot be push-started.
Follow ...