Kia Optima: Front Driveshaft. Repair procedures - Driveshaft Assembly - Driveshaft and axle - Kia Optima TF 2011-2022 Service ManualKia Optima: Front Driveshaft. Repair procedures

Components
1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider a ...

Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove wheel nuts, front wheel and tire from front hub. ...

See also:

TPMS Receiver Schematic Diagrams
Circuit Diagram Connector pin number Pin NO.DiscriptionRemark1-2-3ECU battery terminal4-5CAN_High6CAN_Low7-8-9Ground10-11-12-13-14-15-16-17-18Ignition ON19-20- ...

Tire Replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band 1/2 inch wide (12.7 mm) across the the tread. This shows there is less than 1/16 inch (1.6 mm) of tread left on the t ...

Adjustment
Stop lamp switch clearance adjustment If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~ 0.08in), conform to below. 1. Disconnect the stop lamp switch ...

Copyright © www.kiopman.com 2022