Kia Optima: Installation
| • |
Install the component with the specified
torques. |
| • |
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing.
|
|
| 1. |
Installation is reverse of removal.
Knock sensor installation bolt:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~
17.4 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Remove the intake manifold (Refer to “Intake And
Exhaust System” in EM ...
Description
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina
and is installed both upstream and downstream of the Manifold Catalytic Converter.
The sensor output voltage varies in ...
See also:
Side Body A
Front side member tooling hole (Ø20)
Fender apron tooling hole (Ø10)
Front door upper h ...
Schematic Diagram
...
To keep locks from freezing
To keep the locks from freezing, squirt an
approved de-icer fluid or glycerine into
the key opening. If a lock is covered with
ice, squirt it with an approved de-icing
fluid to remove the ice. ...
Removal
Heated Oxygen Sensor (HO2S). Description and Operation