Kia Optima: Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).

3.	Disconnect the knock sensor connector (A).

4.	Remove the installation bolt (B), and then remove the sensor from the cylinder block.

Knock Sensor (KS). Repair procedures

...

Installation

• Install the component with the specified torques. • Note that internal d ...

See also:

Steering Angle Sensor. Description and Operation
Description The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line.The SAS is used to determine turning di ...

Component (2)
...

Fuse Inspection
1. Be sure there is no play in the fuse holders, and that the fuses are held securely. 2. Are the fuse capacities for each circuit correct? 3. Are the ...

Categories

Kia Optima Manuals

Copyright � www.kiopman.com 2026