Kia Optima: Inspection
| 1. |
Check the driveshaft boots for
damage and deterioration. |
| 2. |
Check the driveshaft spline for
wear or damage. |
| 3. |
Check that there is no water
or foreign material in the joint. |
| 4. |
Check the spider assembly for
roller rotation, wear or corrosion. |
| 5. |
Check the groove inside the joint
case for wear or corrosion. |
| 6. |
Check the dynamic damper for
damage or cracks. |
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove wheel nuts, front wheel
and tire from front hub.
...
•
Do not disassemble the
BJ assembly.
•
Special grease must be
applied to t ...
See also:
Infant or small child
You should be aware of the specific requirements in your country. Child and/or
infant seats must be properly placed and installed in the rear seat. For more information
about the use of these rest ...
To increase cruise control set speed
Follow either of these procedures:
Move the lever (1) up (to RES+) and hold it. Your vehicle will accelerate.
Release the lever at the speed you want.
Move the lever (1) up (to RES+) and re ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and
2.
4.
...
Replacement
Disassembly