Input Speed Sensor Repair procedures
Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
•
...
Smart key unit Repair procedures
Inspection
Smart Key Unit
–
Refer to the BE group - inspection / self diagnosis with GDS.
Smart Key Switch
–
Refer to the BE group - inspection / self diagnosis with GDS.
...
Inspection
1.
Measure terminal-to-terminal
resistance of the blower resistor.
2.
measured resistance is not within
specification, the blower resistor must be replaced. (After re ...