Kia Optima: Removal
| • |
DON’T remove the camshaft position sensor
while the engine is running or right after engine is turned
off. The part and engine oil is hot and can cause burns.
|
|
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable. |
| 2. |
Disconnect the camshaft position sensor connector
(A). |
| 3. |
Remove the installation bolt (B), and then remove
the sensor. 
|
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable. |
| 2. |
Remove the heater protect cover (Refer to "Intake
And Exhaust System" in EM group). |
| 3. |
Disconnect the camshaft position sensor connector
(A). |
| 4. |
Remove the hanger and the protector. |
| 5. |
Remove the installation bolt, and then remove the
sensor. 
|
1.
Check the signal waveform of the CMPS and CKPS using
the GDS.
Specification:
Refer to “Wave Form”
...
•
Install the component with the specified
torques.
•
Note that internal d ...
See also:
Smooth cornering
Avoid braking or gear changing in corners, especially when roads are wet. Ideally,
corners should always be taken under gentle acceleration. If you follow these suggestions,
tire wear will be he ...
Schematic Diagrams
Schematic Diagram
CanisterThe Canister is filled with charcoal and absorbs evaporated
fuel vapor from the fuel tank. The gathered fuel vapor in canister is drawn
into the intake manifold b ...
Headrest
To raise the headrest, simply pull it up to the desired position. To lower the
headrest, press the release lever on the left side grommet, while pushing the headrest
down to the desired position ...
Inspection
Installation