Kia Optima: Installation
| • |
Install the component with the specified
torques. |
| • |
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing. |
|
| • |
Apply the engine oil to the O-ring. |
|
| • |
Insert the sensor in the installation hole
and be careful not to damage. |
|
| • |
Be careful not to damage the sensor housing
and the connector. |
| • |
Be careful not to damage the O-ring.
|
|
| 1. |
Installation is reverse of removal.
Camshaft position sensor installation bolt:9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7
lb-ft)
|
|
•
DON’T remove the camshaft position sensor
while the engine is running or right after engine is turned
...
Description
Knocking is a phenomenon characterized by undesirable vibration
and noise and can cause engine damage. Knock Sensor (KS) is installed on the
cylinder block and senses engine knockin ...
See also:
To resume cruising speed at more than approximately 40 km/h (25 mph)
If any method other than the cruise ON/OFF switch was used to cancel cruising
speed and the system is still activated, the most recent set speed will automatically
resume when the RES+ switch is ...
General Safety Information and Caution
Precautions
General Precautions
Please read the following precautions carefully before performing the airbag system
service.
Observe the instructions described in this manual, or the ...
Removal
[Without EPB]
1.
Remove the rear wheel & tire.
Tightening torque:88.3
~107.9 N.m(9.0 ~11.0 kgf.m, 65.1 ~79.6 lb-ft)
2.
Rem ...
Removal
Knock Sensor (KS). Description and Operation