Kia Optima: Inspection

Camshaft Position Sensor (CMPS). Repair procedures

...

Removal

• DON’T remove the camshaft position sensor while the engine is running or right after engine is turned ...

See also:

Inspection
1. Measure terminal-to-terminal resistance of the blower resistor. 2. measured resistance is not within specification, the blower resistor must be replaced. (After re ...

Auto Light Switch. Repair procedures
Inspection Lighting Switch InspectionWith the multi function switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the ...

26 Brake Control Solenoid Valve(26/B_VFS). Specifications
Specifications Direct control VFS[26/B]▷ Control type : Normal low type Control Pressure kpa(kgf/cm², psi) 9.81~500.14(0.1~5.1, 1.42~72.54) Curren ...