Kia Optima: Inspection
[Motor]
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the EWGA connector.
|
| 3. |
Check that the EWGA is stuck by foreign material.
|
| 4. |
Measure resistance between motor (+) and (-) control
terminals of the motor.
|
| 5. |
Check that the resistance is within the specification.
Specification:
Refer to “Specification” section.
|
|
[Position Sensor]
| 1. |
Turn ignition switch ON. |
| 2. |
Connect the GDS to the data link connector(DLC). |
| 3. |
Check the output voltage at each position of the
EWGA position sensor on current data item within the specification.
Specification:
Refer to “Specification” section.
|
|
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the EWGA connector (A).
3.
Remove the shaft ...
See also:
Inspection
Front Seat Heater Switch
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the floor console upper
cover.(Refer to the BD group - "Console")
...
Panoramaroof Switch. Repair procedures
Inspection
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the overhead console lamp
assembly.(Refer to the BD group - "Roof trim")
...
Brake Pedal. Components and Components Location
Components
1. Cowl bracket
2. Brake pedal member assembly
3. Stop lamp switch
4. Return spring
5. Brake pedal stopper
6. Clevis pin
7. Snap pin
8. Brake pe ...
Removal