Kia Optima: Removal - Electric WGT Control Actuator. Repair procedures - Engine Control System - Engine Control/Fuel System - Kia Optima TF 2011-2026 Service ManualKia Optima: Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Disconnect the EWGA connector (A).

3. Remove the shaft link assembly (B) after removing the C-ring (A).

4. Remove the EWGA after removing the bolts (A).

When carrying the turbo charger, do not hold the rod of the turbo charge to prevent bending the rod.


Inspection
[Motor] 1. Turn ignition switch OFF. 2. Disconnect the EWGA connector. 3. Check that the EWGA is stuck by foreign material. ...

Installation
1. Installation is the reverse order of removal. ...

See also:

One-Touch Wipers
For a single wiping cycle, push the lever forward and release it with the lever in the OFF position. The wipers will operate continuously if the lever is pushed forward and held. ✽ NOTICE ...

Inspection
1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdriver or pliers. ...

Fuel Filler Door Open Switch. Repair procedures
Inspection 1. Remove the driver door trim. (Refer to the BD group - "Front door") 2. Remove the switch assembly connector (A) from the door trim. ...

Copyright www.kiopman.com 2026