Kia Optima: Removal
| 1. | Disconnect the negative (-) battery terminal. |
| 2. | Loosen 2 screws holding the overhead
console (A).
|
| 3. | Disconnect the connectors of
sunroof switch (A) and lamp switch (B) then remove the overhead console
lamp assembly.
|
| 4. | If necessary to replace the bulb,
replace the bulb (C) after disconnecting the connectors.
|
Inspection
Remove the overhead console lamp assembly then check for continuity between terminals.
If the continuity is not as specified, replace the map lamp switch.
...
Installation
1.
Install the overhead console
lamp after connecting the sunroof switch connector and lamp connector.
2.
Install the lens after tightening
2 screws.
...
See also:
Parking Brake
• To set the parking brake, pull the parking brake handle fully and firmly upward
while applying the service brake.
• To release the parking brake, pull the handle up slightly and push the ...
Multimedia jack. Schematic Diagrams
Circuit Diagram
...
Measurement Method
Projected Dimensions
1.
These are the dimensions measured
when the measurement points are projected into the reference plane, and
are the reference dimensions used for b ...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
Copyright www.kiopman.com 2026