Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.
Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal (A).
Tightening torque
:4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft) ...
Inspection
Smart Key Unit
-
Refer to the BE group - inspection
/ self diagnosis with GDS.
Smart Key Switch
-
Refer to the BE group - inspection
/ self diagnosis with GDS.
...
Installation
1.
Install the seat heater switch.
2.
Install the power window switch.
3.
Install the rear door trim.
...