Kia Optima: Installation
|
Be sure to install the harness wires so they will not pinch or interfere
with other parts. |
| • |
Do not open the lid of
the side airbag cover. |
| • |
Make sure that the airbag
assembly cover is installed properly. Improper installation may
prevent the proper deployment. |
|
| 1. |
Remove the ignition key from
the vehicle. |
| 2. |
Disconnect the battery negative
cable and wait for at least three minutes. |
| 3. |
Install the new seat back assembly.
(Refer to the Body group - Seat)
|
| 4. |
Install the front seat assembly.
(Refer to the Body group - Seat)
|
| 5. |
Recline and slide the front seat
forward fully, make sure the harness wires are not pinched of interfere
with other parts. |
| 6. |
Reconnect the battery negative
cable. |
| 7. |
After installing the side airbag
(SAB), confirm proper system operation:
| A. |
Turn the ignition switch
ON; the SRS indicator light should be turned on for about six seconds
and then go off. |
|
The side airbag cannot be disassembled from the seat back assembly, so replace
the seat back assembly when replacing the side airbag. ...
Description
Curtain airbags are installed inside the headliner (LH and RH) and protect the driver
and passenger from danger when side crash occurs. The SRSCM determines deployment
of curtain airb ...
See also:
When to replace seat belts
The entire in-use seat belt assembly or assemblies should be replaced if the
vehicle has been involved in an accident. This should be done even if no damage
is visible. Additional questions concer ...
Inspection
1.
Ignition "ON"
2.
Using the scan tool.
3.
Emit intensive light toward photo
sensor using a lamp, and check the output voltage change.
...
Installation
1.
Make sure of the length of compressor
mounting bolts, and then tighten it A→B→C→D order.
Tightening torque :20.0~32.9N.m
(2.04~3.36kgf.m, 14.7~24 ...
Removal
Curtain Airbag (CAB) Module. Description and Operation