Seat belts should be kept clean and dry. If belts become dirty, they can be cleaned by using a mild soap solution and warm water. Bleach, dye, strong detergents or abrasives should not be used because they may damage and weaken the fabric.
Removal
1.
Remove the timing chain. (Refer
to Timing system in this group)
2.
Install a stopper pin (A) after
compressing the balance shaft chain tensioner.
3.
...
Power Antenna
The antenna will automatically be extended when the radio power switch is turned
“ON” while the ignition key is either in the “ON” or “ACC” position. The antenna
will automatically be retracted ...
Component location
1. Driveshaft (LH)
2. Driveshaft (RH)
1. Driveshaft (LH)
2. Circlip
3. Inner shaft bearing bracket assembly
4. Circlip
5. Driv ...