Kia Optima: Removal - 26 Brake Control Solenoid Valve(26/B_VFS). Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Optima TF 2011-2024 Service ManualKia Optima: Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly. (Refer to "Valve Body" in this group)

Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between sensor signal terminal and sensor g ...

Line Pressure Control Solenoid Vale. Description and Operation
Description Line pressure control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the line pressure. ...

See also:

Illuminated Ignition Switch
Whenever a door is opened, the ignition switch will be illuminated for your convenience. The light will go off approximately 30 seconds after closing the door or when the ignition key is inserted ...

Removal
[Bank 1 / Intake] 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the OTS (A). 3. Disco ...

Restraint of Pregnant Women
Pregnant women should wear lap/shoulder belt assemblies whenever possible according to specific recommendations by their doctors. The lap portion of the belt should be worn AS SNUGLY AND AS LOW AS ...

Copyright © www.kiopman.com 2024