Kia Optima: Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the oil temperature
sensor connector. |
| 3. |
Measure resistance between sensor
signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is
within the specification. |
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional
hydraulic pressure adjustment; however, the hydraulic pre ...
See also:
Dimensions Projected
1.
These are the dimensions
measured when the measurement points are projected from the vehicle's surface,
and are the reference dimensions used for used for body alterations ...
Satellite radio reception
Satellite radio reception You may experience difficulties in receiving SIRIUS®
satellite radio signals in the following situations.
If you are driving in a tunnel or a covered parking area.
...
Traction Control Indicator Lights
The TCS indicator will
illuminate when the ignition key is turned to the “ON” position, but should go off
after 3 seconds. It means the TCS is in the stand-by status and at the moment of
the ...