Kia Optima: Installation
• |
Install the component with the specified
torques. |
• |
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing.
|
|
1. |
Installation is reverse of removal. |
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Lift the vehicle.
3.
Disconnect the canister close valve co ...
See also:
Inspection
Rain Sensing Wiper
1.
In IGN2 ON state, if auto switch
input (LIN communication) is ON then both wiper low relay and wiper high
relay outputs are controlled by the rain sensor input s ...
Changing the Automatic Transaxle Fluid
1. Raise and suitably support the vehicle.
2. Remove the drain plug located at the bottom center front of the transaxle pan.
3. After the oil has drained, completely install a new washer on the plug ...
Finish Damage Repair
Deep scratches or stone chips in the painted surface must be repaired promptly.
Exposed metal will quickly rust and may develop into a major repair expense.
✽ NOTICE
If your vehicle is dama ...