Kia Optima: Removal - Canister Close Valve (CCV). Repair procedures - Engine Control System - Engine Control/Fuel System - Kia Optima TF 2011-2026 Service ManualKia Optima: Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Lift the vehicle.
3. Disconnect the canister close valve connector (A).
4. Disconnect the ventilation hose (B).
5. Remove the fuel tank air filter after removing 2 bolts (C).

6. Release the lever (A) and then rotate the canister close valve (B) in the direction of the arrow in figure.

7. Remove CCV from the fuel tank air filter after coinciding installation parts (A,B).


Inspection
1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the CCV terminal 1 and 2. 4. ...

Installation
• Install the component with the specified torques. • Note that internal d ...

See also:

Headlight Aiming Adjustment
Before performing aiming adjustment, make sure of the following. 1. Keep all tires inflated to the correct pressure. 2. Place the vehicle on level ground and press the front bumper & rear bump ...

Front Seat Adjustment - Power
The driver's seat can be adjusted by using the control knob on the left side of the seat. Before driving, adjust the seat to the proper position so as to easily control the steering wheel, ped ...

Rear Bumper. Repair procedures
Replacement • Use a plastic panel removal tool to remove interior trim pieces to protect from marring the ...

Copyright www.kiopman.com 2026