Kia Optima: Inspection
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the CCV connector. |
3. |
Measure resistance between the CCV terminal 1 and
2. |
4. |
Check that the resistance is within the specification.
Specification:
Refer to "Specification"
|
|
5. |
Disconnect the vapor hose connected with the canister
from the CCV. |
6. |
Connect a vacuum pump to the nipple. |
7. |
Ground the CCV control line and apply battery voltage
to the CCV power supply line. |
8. |
Apply vacuum and check the valve operation.
Specification:
Vacuum maintained
|
|
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Lift the vehicle.
3.
Disconnect the canister close valve co ...
See also:
Component Location (1)
1. Buzzer
2. RF receiver
3. Smart key unit
4. Interior antenna 1
5. Interior antenna 2
6. Trunk antenna
7. Bumper antenna
...
Troubleshooting
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection ProcedureMeasuring Condition of Electronic Parts' Resistance
The measured resistance at hi ...
Electric WGT Control Actuator. Specifications
Specification
[EWGA Position Sensor]
Position
Output Voltage[V]
Operating Angle[°]
Range of Rod [mm], reference
Mechanical Close end ...