Kia Optima: Installation
| 1. |
Apply a light coat of engine
oil to the oil cooler packing surface (A), and then install the oil cooler
with fix bolt (B).
Tightening torque:44.1
~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)
|
|
Fix position of oil cooler stopper(A) where oil cooler resists on
ladder frame stopper (B). |
|
| 2. |
Apply a light coat of engine
oil to the oil filter packing surface (A), and then install the oil filter.
Tightening torque:11.8
~ 15.7 N.m (1.2 ~ 1.6 kgf.m, 8.7 ~ 11.6 lb-ft)
|
|
| 3. |
Connect the oil cooler coolant
hoses (B).
|
| 4. |
Fill the radiator with coolant
and check for leaks. |
1.
Loosen the drain plug, and drain
the coolant. Remove the radiator cap to speed draining.
2.
Disconnect the oil cooler coolant
hoses (A).
3.
...
Inspection
1.
Check the continuity between
the terminal and the body with an ohmmeter.If there is no continuity,
replace the oil pressure switch.
2.
Ch ...
See also:
Armed stage
Park the vehicle and stop the engine. Arm the system as described below.
1. Remove the ignition key from the ignition switch and exit the vehicle.
2. Make sure that all doors (and tailgate) and engi ...
Replacement
1.
Disconnect the negative (-) battery
terminal.
2.
With the (-) driver, remove the
photo sensor (A) from the center of defrost nozzle.
3.
Ins ...
Side Airbag
Your vehicle is equipped with a side airbag in each front seat. The purpose of
the airbag is to provide the vehicle’s driver and/or the front passenger with additional
protection other than th ...
Removal
Oil Pressure Switch. Repair procedures