Inspection
1. | Check the continuity between
the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch.
|
2. | Check the continuity between the terminal and the body when the fine wire is pushed. If there is continuity even when the fine wire is pushed, replace the switch. |
3. | If there is no continuity when
a 50kPa (0.50kgf/cm², 7.25psi) is applied through the oil hole, the switch
is operaing properly. Check for air leakage. If air leaks, the diaphragm is broken. Replace it.
|
Photo Sensor Description and Operation
Description
1.
The photo sensor is located at the right of defrost nozzle.
2.
The photo sensor contains a photovoltaic (sensitive to
sunlight) diode. The solar radiation received by its lig ...
Cowl Top Cover. Repair procedures
Replacement
1.
Remove the cap (B) and remove
the nuts, then remove the wiper arm (A).
Tightening torque :22.6~26.5
N.m(2.3~2.7 kgf.m, 16.6~19.5 lb-ft)
...