Kia Optima: Installation
• |
Install the component with the specified
torques. |
• |
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing. |
|
• |
Insert the sensor in the installation hole
and be careful not to damage.
|
|
1. |
Installation is reverse of removal. |
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Remove the fuel pump service cover (A) in the trunk.
3.
...
Description
Based on information from various sensors, the ECM can calculate
the fuel amount to be injected. The fuel injector is a solenoid-operated valve
and the fuel injection amount is cont ...
See also:
Installation
1.
Reassemble the steering wheel
remote control switch after connecting the connector.
2.
Reassemble the steering wheel.
3.
Reassemble the driver airbag
...
Schematic Diagrams
Circuit Diagram
...
Lumbar Support (Driver’s Seat Only)
You can adjust the lumbar support by moving the lever on the right side of the
driver’s seatback. Pivoting the lever toward the front of the vehicle increases
the lumbar support. Pivoting the le ...