Inspection
Measure a temperature.• | The temperature of wheel surface grip must rise from -20°C to 20°C within 6 minute |
• | The temperature of wheel surface grip must keep 38°C ± 4°C after 25 minute |
• | At that time switch on, all measure point (1~8) |
Inspection
1.
Check signal waveform of Input
& output speed sensor using the GDS.
Specification: Refer to "Signal
Wave Form" section.
...
Overhead Console Lamp. Schematic Diagrams
Circuit Diagram
...
Troubleshooting
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection ProcedureMeasuring Condition of Electronic Parts' Resistance
The measured resistance at hi ...