Kia Optima Manuals

Kia Optima: Removal - Rail Pressure Sensor (RPS). Repair procedures - Engine Control System - Engine Control/Fuel System - Kia Optima TF 2011-2026 Service ManualKia Optima: Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group).
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3. Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).
4. Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. Condition ...

Installation
• Install the component with the specified torques. • Note that internal d ...

See also:

Water pump. Components and Components Location
Components   1. Water pump pulley 2. Water pump sub assembly 3. Water pump gasket 4. Water pump cover 5. Water pump cover gasket 6. O-ring 7. Water inle ...

26 Brake Control Solenoid Valve(26/B_VFS). Description and Operation
Description 26 brake control solenoid valve(26/B_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 26 brake. ...

Fuel gauge
The fuel gauge indicates the approximate amount of fuel remaining in the fuel tank. The fuel tank capacity is given in section 8. The fuel gauge is supplemented by a low fuel warning light, whic ...

Categories

Kia Optima Manuals

Copyright � www.kiopman.com 2026