Kia Optima: Installation
| • |
Install the component with the specified
torques. |
| • |
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing.
|
|
| 1. |
Installation is reverse of removal.
Rail Pressure Sensor Installation:
18.0 ~ 22.0 N.m (1.8 ~ 2.2 kgf.m, 13.3 ~ 16.2 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Release the residual pressure in fuel line (Refer
to “Release Residual P ...
Description
Continuous Variable Valve Timing (CVVT) system advances or
retards the valve timing of the intake and exhaust valve in accordance with
the ECM control signal which is calculated by ...
See also:
Compass Mirror. Repair procedures
Calibration Procedure
If the compass has been calibrated or set to variance zone number incorrectly, or
you are driving in specific places (tunnel, parking lot in building, underground
parking lo ...
Emission Control System
The emissions control system of your vehicle is covered by a written limited
warranty. Please see the warranty information contained in the Warranty Information
Booklet in your vehicle. ...
Fuses
A vehicle’s electrical system is protected from electrical overload damage by
fuses.
This vehicle has two fuse panels, one located in the driver’s side kick panel,
the other in the engine c ...
Removal
CVVT Oil Temperature Sensor (OTS). Description and Operation