Kia Optima: Inspection - Rail Pressure Sensor (RPS). Repair procedures - Engine Control System - Engine Control/Fuel System - Kia Optima TF 2011-2024 Service ManualKia Optima: Inspection

1. Connect the GDS on the Data Link Connector (DLC).
2. Measure the output voltage of the RPS at idle and various engine speed.

Condition
Output Voltage (V)
Idle
 Approx. 1.2
1,500 rpm
 2.0 ~ 2.2
6,300 rpm
 Approx. 2.8


Rail Pressure Sensor (RPS). Repair procedures
...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line (Refer to “Release Residual Pre ...

See also:

Jump starting procedure
1. Make sure the booster battery is 12- volt and that its negative terminal is grounded. 2. If the booster battery is in another vehicle, do not allow the vehicles to touch. 3. Turn off all ...

Window opening and closing
Type A The driver’s door has a master power window switch that controls all the windows in the vehicle. To open or close a window, press down or pull up the front portion of the corresponding ...

Function
Wiper Control Washer Control Coupled With Wiper 1. Under IGN2 = ON, wiper LOW relay is turned ON after T2 from Washer switch ON if washer switch is ON for T1 and wipe ...

Copyright © www.kiopman.com 2024