Kia Optima: Removal
| - |
When servicing the washer
pump, be careful not to damage the washer pump seal. |
| - |
Do not operate the washer
pump before filling the washer reservoir. Failure to do so could
result in premature pump failure.
|
|
| 1. |
Disconnect the negative (-) battery
terminal. |
| 2. |
Remove the front bumper. (Refer
to the BD group - "Front bumper")
|
| 3. |
Remove the washer hose and disconnect
the washer motor connector (A) and level sensor connector (B).
|
| 4. |
Remove the washer motor (A).
| -
|
Washer fluid
may flow out of the opening of reservior. |
|
|
| 5. |
Remove the washer reservoir after
removing 2 bolts (A).
|
1.
With the washer motor connected
to the reservoir tank, fill the reservoir tank with water.
Befo ...
1.
Install the washer reservoir.
Before installing the pump motor, check the filter for foreign materi ...
See also:
Components and Components Location
Component Location
1. Horn switch
2. Horn relay (Engine room compartment)
3. Clock spring
4. Horn (Low)
5. Horn (High)
...
To resume cruising speed at more than approximately 40 km/h (25 mph)
If any method other than the cruise ON/OFF switch was used to cancel cruising
speed and the system is still activated, the most recent set speed will automatically
resume when the RES+ switch is ...
Rear Window Defroster
The defroster heats the window to remove frost, fog and thin ice from the interior
and exterior of the rear window. The ignition switch must be on for the defroster
to operate.
To activate the ...
Inspection
Installation