Kia Optima: Installation| 1. | Installation is the reverse of removal. |
| 2. | Tighten the HECU mounting bolts and nuts to the specified torque. |
| 3. | After installation, bleed the brake system.(Refer to ABS bleeding) |
Removal
Front Wheel Speed Sensor. Components and Components LocationPlacement of a Child Restraint System
We recommend that, whenever possible, you put the child restraint in the center
position of the rear seat and secure it to the vehicle with the lap belt.
If the center rear seat is not available, o ...
To defrost outside windshield
1. Set the mode selection switch to the
position.
When you select position, the system
automatically turns on the outside (fresh) air mode.
2. Set the temperature control knob to the extreme ...
Inspection
1.
Check the signal waveform of the CMPS and CKPS using
the GDS.
Specification:
Refer to “Wave Form”
...