Kia Optima: Installation
Pressure Side Impact Sensor |
1. |
Install the new pressure side
impact sensor with the screws then connect the pressure side impact sensor
connector.
Tightening torque :
3.5 ~ 4.5 N.m (0.36 ~ 0.46 kgf.m, 2.6 ~ 3.3 lb-ft)
|
•
|
Use the specified
screws. |
|
|
2. |
Install the front door trim.
(Refer to the Body group- Front door) |
3. |
Reconnect the battery negative
cable. |
4. |
After installing the pressure
side impact sensor, confirm proper system operation:
A. |
Turn the ignition switch
ON; the SRS indicator light should be turned on for about six seconds
and then go off. |
•
|
You must comply
with the specified tightening torques with the tool specified
because Pressure – Side Impact Sensors (P-SIS) may be broken
or POP-NUT may be rotated. |
•
|
Problems may
occur in the durability of P-SIS or the impact sensing performance
may depreciate if POP-NUT is rotated. |
•
|
The door module
must not be modified because SRSCM judges an impact through
the pressure sensor in the door module. |
|
|
Side Impact Sensor
• |
Do not turn the ignition
switch ON and do not connect the battery cable while replacing the
side impact sensor. |
|
1. |
Install the new side impact sensor
with the bolt then connect the side impact sensor connector.
Tightening torque:
7.0 ~ 9.0 N.m (0.7 ~ 0.9 kgf.m, 5.2 ~ 6.7 lb-ft)
|
|
2. |
Install the center pillar trim
(Refer to the Body group - Interior tirm) |
3. |
Install the door scuff trim.
(Refer to the Body group - Interior tirm) |
4. |
Insert the seat belt to the anchor
pretensioner.
Make sure the lock pin is connected in properly. |
|
5. |
Reconnect the battery negative
cable. |
6. |
After installing the Side Impact
Sensor, confirm proper system operation:
A. |
Turn the ignition switch
ON; the SRS indicator light should be turned on for about six seconds
and then go off. |
|
Pressure Side Impact Sensor
•
Removal of the airbag
must be performed according to the precautions/pr ...
Description
The SRSCM shall monitor the status of the driver and front passenger seat belt buckle.
The SRSCM provides one pin each for the driver and front passenger seat belt buckle
status input ...
See also:
Head Lamps. Description and Operation
HID Head Lamp
1.
Bulb
(1)
ElementsXenon gas:
Xenon gas activates the initial reaction for rapid illuminating.
Molybdenum electrode: anode arcingMetal halide salts: ...
ECM Terminal And Input/Output signal
ECM Terminal Function
Connector [CHTG-AG]
Pin
No.
Description
Connected to
1
Ignition Coil (Cylinder #2) control output [W ...
Maintenance services
You should exercise the utmost care to
prevent damage to your vehicle and
injury to yourself whenever performing
any maintenance or inspection procedures.
Should you have any doubts concerning ...