Kia Optima: Seat Belt Buckle Switch (BS). Description and Operation
Description
The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost voltage supplied by the SRSCM, and uses chassis ground for the signal return. The buckle status shall modify the SRSCM deployment. If the buckle status is unbuckled, the corresponding pretensioner will not be deactivated.
Installation
Pressure Side Impact Sensor
1.
Install the new pressure side
impact sensor with the screws then connect the pressure side impact sensor
connector.
Tightening t ...
See also:
Airbag Warning Label (sunvisor)
To remind you of the dangers of the airbag, airbag warning labels which are now
required by the U.S. National Highway Traffic Safety Administration (NHTSA) are
adhered to the driver’s and pass ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the manifold absolute pressure sensor
connector (A).
...
Component Location Index
Engine Room
1. Receiver Drier
2. Condenser
3. Service Port (High)
4. Service Port (Low)
5. A/C Pressure Transducer
6. Compressor
7. Expansion Val ...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
Copyright � www.kiopman.com 2026