Kia Optima: Removal - Rear combination lamp. Repair procedures - Lighting System - Body Electrical System - Kia Optima TF 2011-2026 Service ManualKia Optima: Removal

Rear Combination lamp (Outside)

1. Disconnect the negative (-) battery terminal.
2. Remove the rear combination lamp cover (A).

3. Replace the tail/stop lamp and turn signal lamp bulbs (A) by turning it counterclockwise.

4. Remove the mounting nuts (4EA).

5. Remove the rear combination lamp (A) after disconnecting the connector (B).

6. Replace the tail/stop lamp and turn signal lamp bulbs (A) by turning the sockets (B) counterclockwise.

Rear Combination Lamp (Inside)
1. Disconnect the negative (-) battery terminal.
2. Remove the trunk trim.

(Refer to the BD group - "Trunk")

3. If the tail lamp bulb should be only replaced without removing lamp assembly, replace the tail lamp bulb (A) after removing the trim cover in the trunk.

Back up lamp bulb is removed after removing the rear lamp assembly.
4. Remove the rear lamp assembly (A) after removing the nuts (3EA) and connector.

5. Replace the tail lamp and back up lamp bulbs (A) by turning the sockets (B) counterclockwise.


Rear combination lamp. Repair procedures
...

Installation
1. Install the rear combination lamp (Inside) assembly. 2. Install the rear combination lamp (outside) assembly. ...

See also:

Cleaning the Lap/Shoulder Belt Webbing
Clean the belt webbing with any mild soap solution recommended for cleaning upholstery or carpet. Follow the instructions provided with the soap. Do not bleach or re-dye the webbing because this m ...

Injector. Schematic Diagrams
Circuit Diagram ...

Trunk Room Light Bulb Replacement
1. Remove the trunk room lamp cover using flat blade screw driver. 2. After replacement of bulb, install the cover. ...

Copyright www.kiopman.com 2026