Kia Optima: Inspection - Front Wiper Motor. Repair procedures - Windshield Wiper/Washer - Body Electrical System - Kia Optima TF 2011-2026 Service ManualKia Optima: Inspection

Speed Operation Check

1. Remove the connector (A) from the wiper motor.

NO
Description
NO
Description
1
GND
4
LOW
2
Parking
5
HI
3
Battery (-)



2. Attach the positive (+) lead from the battery to terminal 3 and the negative (-) lead to terminal 1.
3. Check that the motor operates at low or high speed as below table.

Common sources of contamination are insects, tree sap, and hot wax treatments used by some commercial car washes. If the blades are not wiping properly, clean both the window and the blades with a good cleaner or mild detergent, and rinse thoroughly with clean water.

Installation
1. Install the wiper motor. 2. Install the crank arm. Tighting torque:24.5 ~ 26.4Nm (2.5 ~ 2.7, kgf.m, 18.0 ~ 19.5 lbf.ft) ...

Front Washer Motor. Repair procedures
...

See also:

Torque Converter Control Solenoid Valve (T/CON_VFS). Specifications
Specifications Direct control VFS[T/CON]▷ Control type : Normal low type Control Pressure kpa(kgf/cm², psi) 9.81~500.14(0.1~5.1,1.42~72.54) Curren ...

Removal and Installation
1. Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to drain with speed. 2. Remove the drive belt (A) after turning the drive belt te ...

Front Seat
WARNING - Driver’s Seat Adjusting the driver’s seat with the vehicle in motion could cause loss of control and a serious accident. Do not allow anything to interfere with the normal ...

Copyright � www.kiopman.com 2026