Kia Optima: Inspection - Front Hub / Knuckle. Repair procedures - Front Axle Assembly - Driveshaft and axle - Kia Optima TF 2011-2026 Service ManualKia Optima: Inspection

1. Check the hub for cracks and the splines for wear.
2. Check the brake disc for scoring and damage.
3. Check the knuckle for cracks
4. Check the bearing for cracks or damage.

Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove wheel nuts, front wheel and tire from front hub. ...

Disassembly
1. Remove the snap ring (A). 2. Remove the hub assembly from the knuckle assembly. (1) Install the front knuckle assembly (A) on press. ...

See also:

Troubleshooting
Trouble Shooting Ignition System Symptom Suspect area Remedy Engine will not start or is hard to start (Cranks OK) Ignition lock switch ...

Description
Automatic transaxle system relies on various measurement data to determine the current control status and extrapolate the necessary compensation values. These values are used to control the actuat ...

26 Brake Control Solenoid Valve(26/B_VFS). Specifications
Specifications Direct control VFS[26/B]▷ Control type : Normal low type Control Pressure kpa(kgf/cm², psi) 9.81~500.14(0.1~5.1, 1.42~72.54) Curren ...

Copyright www.kiopman.com 2026