Inspection
1. | Remove the driver door trim. (Refer to the BD group - "Front door") |
2. | Remove the switch assembly connector
(A) from the door trim.
|
3. | Check for continuity between
the terminal No.1 and No.2.
|
4. | Remove the fuel filler door switch
assembly (A) after pressing the fixing clips (B).
|
General Safety Information and Caution
Safety Precaution
Since hybrid vehicles contain a high voltage battery, if the
high voltage system or vehicles are handled incorrectly, this might lead
to a ser ...
TPMS Receiver Schematic Diagrams
Circuit Diagram
Connector pin number
Pin NO.DiscriptionRemark1-2-3ECU battery terminal4-5CAN_High6CAN_Low7-8-9Ground10-11-12-13-14-15-16-17-18Ignition ON19-20-
...
Removal
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
3.
...