Inspection
1. | Remove the trunk room left side
trim. (Refer to the BD group - "Interior trim") |
2. | Remove the fuel filler door release
actuator (A) after loosening the mounting bolts.
|
3. | Disconnect the release actuator
connector (A).
|
4. | Check for continuity between
terminal No.1 and No.2. If there is no continuity, replace the fuel filler door release actuator. |
Seat height
To change the height of the seat, move the lever upwards or downwards.
To lower the seat cushion, push down the lever several times.
To raise the seat cushion, pull up the lever several times. ...
Checking the engine oil level
2.4 engine
2.0 engine
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach
normal operating temperature.
3. Turn the engine off and wait for a few
min ...
Installation
1.
Installation is the reverse of
removal.
Make sure vehicle does not roll before setting room sid ...