As a reminder to the
driver and passenger, safety belt warning light will blink for approximately 6 seconds
each time you turn the ignition switch ON.
If the driver's lap/shoulder belt is not fastened when the key is turned ON or if it is unfastened after the key is turned ON, the safety belt warning light blinks for approximately 6 seconds.
Thermostat. Repair procedures
...
Downshifting
When you must slow down in heavy traffic or while driving up steep hills, downshift
before the engine starts to “labor’’. Downshifting reduces the chance of stalling
and gives better acceleration ...
Replacement (With EPB)
Rear brake pads
1.
Remove the rear wheel & tire.
2.
Connect the GDS to the data link
connector located underneath the dash panel.
3.
Ignition "ON& ...