Kia Optima: Suspension System. Tires/Wheels. Wheel. Repair procedures

Hub nut tightening sequence

Tighten the hub nuts as follows.

Tightening torque:

88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

When using an impact gun, final tightening torque should be checked using a torque wrench.

Run out inspection

1.	Jack up the vehicle.

2.

Measure the wheel Run-out by using a dial indicator as illustration below.

Run-out	Aluminum	Steel
Radial mm(in.)	Below 0.3(0.012)	Below 1.4(0.055)
Lateral mm(in.)	Below 0.3(0.012)	Below 0.9(0.035)

3.	If measured value exceeds the standard value, replace the wheel.

Suspension System. Tires/Wheels. Tire. Repair procedures

Tire wear 1. Measure the tread depth of the tires. Tread depth [limit] : 1.6 mm (0.063 in.) 2. If the remaining tread depth (A) is less ...

Suspension System. Tires/Wheels. Alignment. Repair procedures

...

See also:

Restraint of Pregnant Women
Pregnant women should wear lap/shoulder belt assemblies whenever possible according to specific recommendations by their doctors. The lap portion of the belt should be worn AS SNUGLY AND AS LOW AS ...

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the CCV terminal 1 and 2. 4. ...

Components and Components Location
Components Location 1. Fuel Tank 2. Fuel Pump 3. Fuel Filter 4. Fuel Pressure Regulator 5. Canister 6. Fuel Tank Air Filter 7. Fuel Tank Band 8. Fuel Tank ...

Categories

Kia Optima Manuals

Copyright � www.kiopman.com 2026