Kia Optima: Removal
| 1. | Disconnect the battery negative cable and wait for at least three minutes before beginning work. |
| 2. | Remove the driver airbag module
from the steering wheel after pressing the snap fit pin stopper.
|
| 3. | Remove the wiring fixing clip(C)
and disconnect the horn connector (A).
|
| 4. | Release the connector locking
pin, then disconnect the driver airbag module connector(B).
|
| 5. | Remove the steering wheel and
steering wheel column shroud. (Refer to the Steering System group- Steering
Column and Shaft)
|
| 6. | Disconnect the clock spring and
horn connector, then remove the clock spring.
|
Inspection
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace the airbag
module with a new one.
...
See also:
Installation
1.
Connect the audio unit connectors
and cables.
2.
Install the audio unit.
3.
Install the center fascia upper
panel.
4.
Install the h ...
Air intake control
The air intake control is used to select outside (fresh) air position or recirculated
air position.
To change the air intake control position, push the control button.
Recirculated air position
...
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove wheel nuts, front wheel
and tire from front hub.
...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
Copyright www.kiopman.com 2026