Kia Optima: Inspection
If any improper parts are found during the following inspection, replace the airbag
module with a new one.
|
Never attempt to measure the circuit resistance of the airbag module (squib)
even if you are using the specified tester. If the circuit resistance is
measured with a tester, accidental airbag deployment will result in serious
personal injury. |
| 1. |
Check pad cover for dents, cracks
or deformities. |
| 2. |
Check the airbag module for denting,
cracking or deformation. |
| 3. |
Check hooks and connectors for
damage, terminals for deformities, and harness for binds. |
| 4. |
Check airbag inflator case for
dents, cracks or deformities.
|
| 5. |
Install the airbag module to
the steering wheel to check for fit or alignment with the wheel. |
Clock Spring
| 1. |
If, as a result of the following
checks, even one abnormal point is discovered, replace the clock spring
with a new one. |
| 2. |
Check connectors and protective
tube for damage, and terminals for deformities.
|
1.
Disconnect the battery negative
cable and wait for at least three minutes before beginning work.
2.
Remove the driver airbag module
from the steering wheel after p ...
1.
Remove the ignition key from
the vehicle.
2.
Disconnect the battery negative
cable from battery and wait for at least three minutes before beginning
work.
...
See also:
Front Bumper. Repair procedures
Replacement
•
Put on gloves to protect
your hands.
•
Use a plastic panel removal ...
Removal
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the auto light sensor
(A) from crash pad upper side by using screw (-) driver.
...
Adjustment
Adjusting method for T/M control cable
1.
Make sure vehicle does not roll
before setting room side shift lever and T/M side manual control lever to
"N" pos ...
Removal
Installation