Kia Optima: Installation - Driver Airbag (DAB) Module and Clock Spring. Repair procedures - Airbag Module - Restraint - Kia Optima TF 2011-2026 Service ManualKia Optima: Installation

1. Remove the ignition key from the vehicle.
2. Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
3. Connect the clock spring harness connector and horn harness connector to the clock spring.
4. Set the center position by setting the marks between the clock spring and the cover into line. The mark (▶◀) should be matched by turning the clock spring clockwise to the stop and then 2.0 revolutions counterclockwise.

5. Install the steering wheel column shroud and the steering wheel. (Refer to the Steering System group- Steering Column and Shaft)
6. Connect the Driver Airbag (DAB) module connector and horn connector, and then install the Driver Airbag (DAB) module on the steering wheel.
7. Connect the battery negative cable.
8. After installing the airbag, confirm proper system operation:
A. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
B. Make sure horn button works.

Inspection
Driver Airbag (DAB) If any improper parts are found during the following inspection, replace the airbag module with a new one. ...

Passenger Airbag (PAB) Module. Description and Operation
Description The passenger airbag (PAB) is installed inside the crash pad and protects the front passenger in the event of a frontal crash. The SRSCM determines if and when to deploy the PAB. ...

See also:

Air Flow Control (Mode Switch)
The mode selection button controls the direction of the air flow through the ventilation system. The air flow outlet port is same as manual climate control system. Face position Air flow is dir ...

Anti-Lock Brake System (ABS) Warning Light
This light illuminates when you start the engine. The light will go off if the ABS is operating normally. Also, this light comes on if the key is turned to ON, and then goes off in 2-3 seconds i ...

Inspection
1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim.(Refer to the BD group - "Roof trim") 3. Disconnect the panoram ...

Copyright www.kiopman.com 2026