Kia Optima: Road Warning
Hazard Warning Flasher
The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle. It should be used whenever emergency repairs are being made, when the vehicle is stopped near the edge of a roadway, or whenever your vehicle is in distress.
Depress the flasher switch to activate at any time. The flasher switch is located in the center console switch panel. All turn signal lights will flash simultaneously.
- The hazard warning flasher operates whether your vehicle is running or not.
- The turn signals do not work when the hazard flasher is on.
- Care must be taken when the hazard warning flasher is used while the vehicle is being towed. Local regulations may prohibit using it in this manner.
Overheating
If your temperature gauge indicates overheating, if you experience a loss of
power, or if you hear a loud knocking or pinging noise, the engine has probably
overheated. Should any of these symptom ...
See also:
Installation
1.
Remove the ignition key from
the vehicle.
2.
Disconnect the battery negative
cable and wait for at least three minutes.
3.
Install the seat belt ...
Jump starting
Jump starting can be dangerous if done
incorrectly. Therefore, to avoid harm to
yourself or damage to your vehicle or
battery, follow these jump starting procedures.
If in doubt, we strongly r ...
Blower Unit. Repair procedures
Replacement
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the crash pad and heater
blower unit.(Refer to HA group-heater unit)
3.
Re ...