To program a device to HomeLink using a HomeLink button previously trained, follow these steps:
1. Press and hold the desired HomeLink button. Do not release until step 4 has been completed.
2. When the indicator light begins to flash slowly (after 20 seconds), hold the handheld transmitter 1 to 3 inches away from the bottom of the mirror.
3. Press and hold the transmitter button (or, if necessary, press and "cycle," as described in the ‘"Gate Operator & Canadian Programming" portion of this text).
4. The HomeLink indicator light will flash slowly at first, then rapidly, indicating successful programming. Release both buttons.
Gate Operator Programming & Canadian Programming
During programming, your hand-held transmitter may automatically stop transmitting.
Continue to press and hold the HomeLink button while you press and repress ("cycle")
your handheld tran ...
Replacement
Standard values, such as torques and certain adjustments, must be strictly
observed in the reassembly of all parts.If removed, the following
parts should always be replaced with new ones.
...
Engine Exhaust Gas Precautions
WARNING
Engine exhaust gases contain carbon monoxide (CO). Though colorless and odorless,
it is dangerous and could be lethal if inhaled. Follow the instructions below to
avoid CO poisoning. ...