Room Lamp
1. | Disconnect the negative(-) battery terminal. |
2. | Carefully remove the lamp lens
(A) from the room lamp with a flat-tip screwdriver.
|
3. | Replace the bulbs (A) and remove
the screws if it is necessary.
|
4. | Remove the room lamp assembly
(A) after disconnecting the connector (B).
|
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the vanity lamp (A) by
pressing the clip (B) with a small screwdriver.
|
3. | Remove the vanity lamp assembly after disconnecting the connector. |
Camshaft Position Sensor (CMPS). Schematic Diagrams
Circuit Diagram
...
Use high quality ethylene glycol
coolant
Your vehicle is delivered with high quality
ethylene glycol coolant in the cooling
system. It is the only type of coolant that
should be used because it helps prevent
corrosion in the cooling ...
Operation of the rear parking assist system
Operating condition
This system will activate when backing up with the ignition switch ON.
The sensing distance while the rear parking assist system is in operation
is approximately 120 cm (4 ...