Kia Optima: Replacement (Without EPB)
Rear brake pads
| 1. | Loosen the guide rod bolt (B)
and pivot the caliper (A) up out of the way.
|
| 2. | Replace pad shim (D), pad retainers
(C) and brake pads (B) in the caliper carrier (A).
|
Removal
[Without EPB]
1.
Remove the rear wheel & tire.
Tightening torque:88.3
~107.9 N.m(9.0 ~11.0 kgf.m, 65.1 ~79.6 lb-ft)
2.
Rem ...
Replacement (With EPB)
Rear brake pads
1.
Remove the rear wheel & tire.
2.
Connect the GDS to the data link
connector located underneath the dash panel.
3.
Ignition "ON& ...
See also:
Repair procedures
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS Pro to check for DTCs. Refer to
the Diagnostic Trou ...
Auto Head Lamp Leveling Unit. Schematic Diagrams
Circuit Diagram
...
Speed sensing door lock system (if equipped)
All doors will be automatically locked after the vehicle speed exceeds 15 km/h
(9.3 mi/h). And all doors will be automatically unlocked when you turn the engine
off or when you remove the ignition ...
Copyright © www.kiopman.com 2024