Kia Optima: Removal
| 1. | Disconnect the negative(-) battery terminal. |
| 2. | Remove the front door trim panel. (Refer to the BD group - "Front door") |
| 3. | Remove the power window switch
module (A) from the door trim after loosening the mounting screws (3EA).
|
Inspection
Driver Door Lock Switch Inspection
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the front door trim panel.
(Refer to the BD group - "Front door" ...
Installation
1.
Install the power window switch
module.
2.
Install the door trim panel after
reconnecting the relevant connectors
...
See also:
Replacement (Without EPB)
Rear brake pads
1.
Loosen the guide rod bolt (B)
and pivot the caliper (A) up out of the way.
Tightening torque:21.6
~ 31.4 N.m (2.2 ~ 3.2 kgf.m, 15.9 ~ 23.1 lb-ft)
...
Limp home (override) procedure
When you turn the ignition switch to the ON position, if the immobilizer indicator
() goes off after blinking 5 times, your
transponder equipped in the ignition key is out of order. You cannot sta ...
Output Speed Sensor. Troubleshooting
Signal Waveform
Fig 1) Input/Output speed sensor at low speedFig 2) Input/Output speed sensor
at high speed
...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
Copyright www.kiopman.com 2026