Kia Optima: Removal
| 1. | Disconnect the negative (-) battery terminal. |
| 2. | Remove the crash pad lower panel
(A).
|
| 3. | Remove the reinforce panel after loosening the mounting bolts. |
| 4. | Remove the duct (A) after removing
the screw.
|
| 5. | Remove the accelerator pedal
module. (Refer to the FL group - "accelerator pedal") |
| 6. | Remove the body control module
after loosening nut (1EA) and screw (1EA) and disconnecting the connectors
(A).
|
Trouble Diagnostics When Using GDS
1.
The body control module can diagnose
by using the GDS more quickly.The BCM communicates with the GDS and then
reads the input/output value and drives the actuator.
...
Installation
1.
Install the body control module.
2.
Install the accelerator.
3.
Install the reinforce panel.
4.
Install the crash pad lower panel.
...
See also:
Certification label
The certification label is located on
the driver's door sill at the center pillar.
This label shows the maximum
allowable weight of the fully loaded
vehicle. This is called the GVWR
(Gros ...
Highway driving
Tires
Adjust the tire inflation pressures to specification. Low tire inflation pressures
will result in overheating and possible failure of the tires.
Avoid using worn or damaged tires which may r ...
Anchor Pretensioner (APT). Description and Operation
Description
Front seat belt anchor pretensioner operates as well as belt pretensioner at the
same time If it gets into its deploy condition after a collision. It is located
at near anchor on fron ...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
