Kia Optima: General
| 1. | Basically, all measurements in this manual are taken with a tracking gauge. |
| 2. | When a measuring tape is used, check to be sure there is no elongation, twisting or bending. |
| 3. | For measuring dimensions, both projected dimension and actual-measurement dimension are used in this manual. |
Measurement Method
Projected Dimensions
1.
These are the dimensions measured
when the measurement points are projected into the reference plane, and
are the reference dimensions used for b ...
See also:
Repair procedures
Inspection
Self Diagnosis With GDSSmart key system defects can be quickly diagnosed with
the GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosis.
The following thr ...
Intake Air Temperature Sensor (IATS). Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and
4.
...
Replacement
Front brake pads
1.
Loosen the guide rod bolt (B)
and pivot the caliper (A) up out of the way.
Tightening torque:21.6
~ 31.4 N.m (2.2 ~ 3.2 kgf.m, 15.9 ~ 23.1 lb-ft)
...
Copyright © www.kiopman.com 2025