Kia Optima: Measurement Method
| 1. |
These are the dimensions measured
when the measurement points are projected into the reference plane, and
are the reference dimensions used for body alterations. |
| 2. |
If the length of the tracking
gauge probes is adjustable, make the measurement by lengthening one probe
by the amount equivalent to the difference in height of the two surfaces.
|
| Actual-Measurement Dimensions |
| 1. |
These dimensions indicate the
actual linear distance between measurement points, and are the reference
dimensions for use if a tracking gauge is used for measurement. |
| 2. |
Measure by first adjusting both
probes to the same length (A=A').
|
Check the probes and gauge itself to make sure there is no free
play. |
|
| 1. |
Measurements should be taken
at the hole center.
|
1.
Basically, all measurements in
this manual are taken with a tracking gauge.
2.
When a measuring tape is used,
check to be sure there is no elongation, twisting or ...
See also:
Inspection
Front brake disc thickness check
1.
Check the brake pads for wear
and fade.
2.
Check the brake disc for damage
and cracks.
3.
Remove all rust and conta ...
Outside Rearview Mirror Heater
The outside door mirror heater is actuated in connection with the rear window
defroster. To heat the outside door mirror glass, push the switch for the rear window
defroster.
The outside door mir ...
Non-operational conditions of rear parking assist system
The rear parking assist system may not operate properly when:
1. Moisture is frozen to the sensor. (It will operate normally when the moisture
has been cleared.) 2. The sensor is covered with forei ...
General
